Recherche « Sierra Wireless »
3 CVE
-
CVE-2026-15461 5.3 Moyenne
zephyrproject zephyr
The Sierra Wireless HL78xx modem GNSS driver (drivers/modem/hl78xx/, later drivers/modem/vendor_standalone/hl78xx/) embeds a generic struct gnss_nmea0183_match_data match_data inside struct hl78xx_gnss_data. The generic NMEA0183 match helper (drivers/gnss/gnss_nmea0183_match.c) requires that context to be the first member because its callbacks cast user_data directly to struct gnss_nmea0183_match_data . In the affected releases match_data was the second member (after const struct device dev), so it sat at a non-zero offset while gnss_nmea0183_match_init() initialized it at the correct address. The registered NMEA handlers instead pass the whole device data object (data->devices.gnss->data, offset 0), producing an offset-shifted type confusion between where state is initialized and where the parse callbacks read and write it. When NMEA sentences from the GNSS receiver are parsed, the GGA/RMC callbacks write parsed fix data into the wrong location within the struct, and the GSV callback (gnss_nmea0183_match_gsv_callback, active under CONFIG_GNSS_SATELLITES) reads its satellites pointer and bound from the wrong offsets — non-pointer bytes of struct hl78xx_gnss_data — and then writes parsed struct gnss_satellite entries through that bogus pointer. This is a write through an uninitialized/wild pointer with a garbage bound. The NMEA handlers are registered by default (CONFIG_HL78XX_GNSS_SOURCE_NMEA is the default GNSS source) on devices using the HL78xx GNSS. The driver runs in kernel context and the NMEA data originates from the GNSS radio front-end, so a party able to influence the GNSS signal (for example GNSS/GPS spoofing at radio proximity) can drive the kernel-side parser into the faulty write. The most likely impact is a crash (denial of service) because the bogus pointer resolves to a fixed near-NULL value, with adjacent-memory corruption possible on MMU-less targets. Confidentiality is not affected. Exploitation requires the satellites feature to be enabled and active, so attack complexity is high.
-
CVE-2026-12520 6.4 Moyenne
zephyrproject zephyr
The Sierra Wireless HL7800 cellular modem driver (drivers/modem/vendor_standalone/hl7800.c, located at drivers/modem/hl7800.c in v4.4.0 and earlier) parses AT responses with roughly twenty handlers that call net_buf_linearize(value, sizeof(value), *buf, 0, len) into a 128-byte stack buffer and then write value[out_len] = 0. Because net_buf_linearize() (lib/net_buf/buf.c) can return a count equal to its destination-length argument, a field that exactly fills the buffer makes the terminating NUL land one byte past the end, a single-byte out-of-bounds write into adjacent stack memory. The +KCELLMEAS cell-measurement handler on_cmd_atcmdinfo_rssi() is worse: it passed the wire length len as the destination size (net_buf_linearize(value, len, *buf, 0, len)), so a response line longer than 128 bytes overflows the value stack buffer with attacker-influenceable content. The line length comes from net_buf_findcrlf(), which accumulates bytes across the whole net_buf fragment chain and is not bounded to 128, so an over-long line reaches the defect. The data originates from the cellular modem over UART, driven by the network: operator-scan results, +CGCONTRDP IP/DNS info, socket indications, and +KCELLMEAS neighbour-cell reports. An attacker able to shape what the modem emits — a rogue base station, a compromised modem baseband, or a remote peer feeding oversized response framing — can drive a line past 128 bytes. The handlers run in the driver's RX thread in kernel context, so the corruption is kernel-side. The +KCELLMEAS path is a full stack buffer overflow whose worst case is code execution in kernel context and whose floor is a reliable crash; the remaining sites are single-byte NUL out-of-bounds writes. Exploitation requires the modem to emit an over-long AT response line, giving high attack complexity over an adjacent (cellular radio) vector. The fix passes sizeof(dst) - 1 (and correct explicit bounds for the IMSI and +KCELLMEAS sites) so the terminator always stays in bounds.
-
Sierra Wireless · Sierrawireless aleos
An exploitable remote code execution vulnerability exists in the upload.cgi functionality of Sierra Wireless AirLink ES450 FW 4.9.3. A specially crafted HTTP request can upload a file, resulting in executable code being uploaded, and routable, to the webserver. An attacker can make an authenticated HTTP request to trigger this vulnerability.