Semaine du 19 octobre au 25 octobre 2026

Linux

In the Linux kernel, the following vulnerability has been resolved: bnxt_en: fix DMA mapping length for padded small packets Stefan Fleischmann reported Intel IOMMU DMA Read faults on BCM57412 NetXtreme-E NICs when transmitting packets on VLAN/macvlan interfaces: DMAR: [DMA Read NO_PASID] Request device [18:00.0] fault addr 0xfc499000 [fault reason 0x06] PTE Read access is not set bnxt_en 0000:18:00.0 eno1np0: Abandoning msg {0xb4 0x41a} len: 0 due to firmware status: 0x2000001 ... NETDEV WATCHDOG: eno1np0 (bnxt_en): transmit queue 0 timed out The fault address (0xfc499000) is on an exact 4KB page boundary, pointing to a DMA read buffer overrun. In bnxt_start_xmit(), packets smaller than BNXT_MIN_PKT_SIZE (52 bytes), such as 42-byte untagged ARP frames, are padded: if (length < BNXT_MIN_PKT_SIZE) { pad = BNXT_MIN_PKT_SIZE - length; if (skb_pad(skb, pad)) goto tx_kick_pending; length = BNXT_MIN_PKT_SIZE; } mapping = dma_map_single(&pdev->dev, skb->data, len, DMA_TO_DEVICE); ... dma_unmap_len_set(tx_buf, len, len); However, 'len' was initialized earlier to skb_headlen(skb) (e.g. 42 bytes) and is left unadjusted after padding. Consequently, dma_map_single() and dma_unmap_len_set() map and track only 42 bytes. Later, the hardware TX buffer descriptor is programmed with the padded length: txbd->tx_bd_len_flags_type = cpu_to_le32(((len + pad) << TX_BD_LEN_SHIFT) | flags | TX_BD_FLAGS_PACKET_END); The NIC DMA engine is thus instructed to read 52 bytes from a region where only 42 bytes were DMA-mapped. If skb->data ends near the boundary of a 4KB page (within 'pad' bytes of the next page), the hardware DMA read overruns into the unmapped adjacent page, triggering an IOMMU fault. This issue was exposed after commit 447cbe95ebb9 ("vlan: fix skb_under_panic and races when toggling HW VLAN offload") because reserving extra VLAN headroom rounded LL_RESERVED_SPACE from 48 up to 64 bytes, shifting skb->data offsets and potentially causing small frames to land right against page boundaries. Fix this by using skb_put_padto(skb, BNXT_MIN_PKT_SIZE) in bnxt_start_xmit(), before skb_shinfo(skb)->nr_frags is sampled, because padding might linearize the skb. This ensures skb->len and skb_headlen(skb) reflect the padded size so that dma_map_single() maps the full buffer and the descriptor length is consistent. This also removes the temporary 'pad' variable and masking logic. The padding is done after the SW USO branch, otherwise bnxt_sw_udp_gso_xmit() would account the padding as UDP payload and send it in extra segments. Note that SW USO segments are still not padded: with IPv4, a segment carrying less than 10 bytes of UDP payload (small gso_size, or a short last segment) is sent as a frame shorter than BNXT_MIN_PKT_SIZE. This is a separate issue, left for a followup patch.

Linux

In the Linux kernel, the following vulnerability has been resolved: ibmveth: h_free logical LAN on open-fail after register ibmveth_open() registers the logical LAN, then allocates the RX buffer pools. A pool failure jumps to out_free_buffer_pools without h_free_logical_lan(), so PHYP still owns the buffer-list page when it is unmapped. request_irq() failure already issued the hypercall before taking the same label. Move that h_free to the shared post-register unwind so both paths deregister before the buffer list is unmapped.

Linux

In the Linux kernel, the following vulnerability has been resolved: net: xilinx: axienet: Free outstanding DMA buffers on dmaengine stop In the dmaengine path the driver pre-submits RX buffers and holds in-flight TX buffers whose SKBs are DMA-mapped by the driver and freed only in the completion callbacks. On ndo_stop() dmaengine_terminate_sync() aborts these descriptors without running their callbacks, and the driver then frees only the ring shells, leaking every SKB still owned by the engine and its DMA mapping on each ifdown. With 128 RX buffers pre-posted per channel, the mapping leak can eventually exhaust a limited IOMMU aperture. Clear the slot's skb in the TX and RX callbacks so a non-NULL skb marks a slot that still owns a live, DMA-mapped buffer, and on stop unmap and free every such buffer. axienet_dma_rx_cb() runs from the DMA tasklet and re-arms the RX ring on each completion, so it can race axienet_stop(): a completion may submit a fresh buffer after dmaengine_terminate_sync() has returned, leaving the channel armed with a buffer the teardown then frees while the engine may still write into it (dma_release_channel() does not stop it either). Add a lock that axienet_dma_rx_cb() holds across the @stopping check and the resubmit, and axienet_stop() holds to set @stopping before terminating. Once @stopping is set no callback can arm a new buffer, and any armed just before is aborted by the terminate, so teardown only frees buffers the engine no longer owns.

Linux

In the Linux kernel, the following vulnerability has been resolved: xfs: stop exchanging reflink flags when exchanging mappings When an exchange covers both files from offset 0 to i_disk_size, xmi_can_exchange_reflink_flags() assumes every mapping moved and hands the reflink flag over to the other file. That assumption is wrong. A file can still own shared blocks past i_disk_size, e.g. after EXCHANGE_RANGE_TO_EOF sets a smaller size without unmapping anything. The flag is cleared anyway, and the next write to such a block happens in place instead of CoW, corrupting the other file that shares it. Commit a23eca88448e ("xfs: fix exchange-range reflink flag clearing issue with INO1_WRITTEN") fixed one instance of this. Rather than add another special case, stop moving the flags. xfs_exchmaps_ensure_reflink() already sets the flag on both inodes before the exchange, so both just keep it. Nothing sets CLEAR_INO{1,2}_REFLINK anymore. Intents logged by older kernels may still carry them; recovery already masks them off, so they stay in the log format mask and are ignored. XFS_IOC_SWAPEXT has the same problem: it moves the reflink flag from one inode to the other along with the extents. Just removing that is not enough here: the exchange path flags both inodes up front in xfs_exchmaps_ensure_reflink(), but swapext has no such step, so the inode receiving the shared extents would be left without the flag. Set it on both inodes instead, and make sure both have a CoW fork, since an inode with the reflink flag is expected to have one. The flag now stays until FALLOC_FL_UNSHARE_RANGE, xfs_scrub, or a truncate to zero removes it.

Linux

In the Linux kernel, the following vulnerability has been resolved: xfs: fix exchange-range-to-eof file size exchange Norbert Szetei posted a patch containing an incomplete description of a bug in XFS_IOC_EXCHANGE_RANGE's TO_EOF flag. The bug tricks exchange-range into modifying a file so that it has shared blocks starting beyond EOF, which is never allowed because files never have written data beyond EOF, and you can only share written data blocks. This is key to all the incorrect behavior that follows. Eventually I got from Norbert a description of what's going wrong: > Fair. Here it is with physical block numbers, 4k blocks. peer is the file > that gets rewritten and file1 is the one that ends up with the flag > cleared. > > Start, nothing shared: > > peer size 4096 -> [100] > file1 size 12288 -> [200] [201] [202] > donor1 size 4096 -> [300] > donor2 size 4096 -> [400] > > 1. FICLONERANGE peer's block into file1's middle slot: > > peer size 4096 -> [100] > file1 size 12288 -> [200] [100] [202] reflink flag set > ^^^^^ both files own block 100 > > 2. XFS_IOC_EXCHANGE_RANGE file1 against donor1, file1_offset 0, > file2_offset 8192, length 0, TO_EOF. One block is exchanged, and the sizes > are exchanged with it: > > file1 size 4096 -> [200] [100] [300] reflink flag set > ^^^^^^^^^^^ still owned, now past the size > donor1 size 12288 -> [202] > > file1 says it is one block long while it still owns three. Nothing was > unmapped. file2_offset is block 2, so this exchange cannot clear a flag. > > 3. XFS_IOC_EXCHANGE_RANGE file1 against donor2, both offsets 0, length 4096. > By i_disk_size this is two one-block files exchanging everything, so > xmi_can_exchange_reflink_flags() agrees and the flag is cleared: > > file1 size 4096 -> [400] [100] [300] reflink flag CLEARED > donor2 size 4096 -> [200] > > Block 100 is still shared with peer. > > 4. pwrite(file1, 4096, 4096), which is file1's second slot, block 100. > xfs_is_cow_inode(file1) is false, so no CoW: > > peer size 4096 -> [100] same block, new contents > > Block 100 is the only one that matters here. PoC below, it reads a file > called peer in the current directory. The filesystem needs reflink and > exchange-range, which mkfs.xfs 7.x turns on by default. So yes, TO_EOF is screwing up the file size even if it's actually exchanging the data block correctly. The following is the intended behavior of XFS_EXCHANGE_RANGE_TO_EOF, as described by its manpage: "Ignore the length parameter. All bytes in file1_fd from file1_offset to EOF are moved to file2_fd, and file2's size is set to (file2_offset+(file1_length-file1_offset)). Meanwhile, all bytes in file2 from file2_offset to EOF are moved to file1 and file1's size is set to (file1_offset+(file2_length-file2_offset))." In other words, if we only exchange a portion of the file data, then we should only exchange the portion of the file size that relates to the exchanged data. Unfortunately, the code swaps the ondisk file size and the incore file sizes, which is incorrect if the caller passes in a nonzero offset. Having confused the file sizes, the PoC uses a second exchange-range call on what looks like a non-reflinked single-block file. Because the file size is set incorrectly, exchange-range thinks it's exchanging the full contents of two files and clears the reflink flag on the broken file. That enables an extending write of the broken file to rewrite the shared block that's just past EOF. This has become known colloquially as refluxfs. Once the file sizes are set correctly, the second exchange-range no longer thinks that it's doing a full-contents swap, so it won't clear the reflink flag on either of its file arguments. Norbert followed up to an earlier version of this patch with a second complaint about us not handling the i_disk_size state correctly: > The offsets are bounded against the incore i_size but subtracted from > ---truncated---

Linux

In the Linux kernel, the following vulnerability has been resolved: drm/imagination: Fix reference and vm_bo handling in remap() When a map overlaps part of an existing mapping, pvr_vm_gpuva_remap() splits the mapping into prev/next parts covering what the request did not take, instead of creating something new. It gets two things wrong. - A GEM reference is taken for each part but it's never needed and never dropped, so it leaks one reference per split (remap-next-in-2m in tests/imagination/pvr_vm_map.c): CRITICAL: 33558528 bytes of shmem still held after close - The parts still belong to the original object being split, but pvr_vm_gpuva_remap() links them to ctx->gpuvm_bo, the new object's vm_bo: prev_va --obj--> BO_A BO_B <--obj-- vm_bo (ctx->gpuvm_bo) \___________link___________/ (mismatch: BO_A != BO_B) drm_gpuva_link() catches the mismatch: WARNING: drivers/gpu/drm/drm_gpuvm.c:2108 at drm_gpuva_link+0x2ec/0x310 drm_WARN_ON(obj != vm_bo->obj) Call trace: drm_gpuva_link pvr_vm_gpuva_remap __drm_gpuvm_sm_map pvr_vm_map pvr_ioctl_vm_map Link them to op->remap.unmap->va->vm_bo instead. The locking of the GPUVA lists of the other objects touched by a split is not addressed here; it is handled by switching the GPUVM to immediate mode.

Linux

In the Linux kernel, the following vulnerability has been resolved: dpaa2-switch: fix the error path in dpaa2_switch_rx() In case of an error in dpaa2_switch_rx(), the dpaa2_switch_free_fd() function is called in order to free the FD. This is incorrect since the dpaa2_switch_free_fd() is intended to be used on Tx frame descriptors, meaning that it expects in the software annotation area of the FD data to find a valid skb pointer on which to call dev_kfree_skb(). Fix this by extracting the dma_unmap_page() from dpaa2_switch_build_linear_skb() directly into the dpaa2_switch_rx() function. This allows us to directly use free_pages() in case of an error before an SKB was created and kfree_skb() afterwards.