Octobre 2026

Linux

In the Linux kernel, the following vulnerability has been resolved: openvswitch: fix soft lockup in the netlink flow dump A production compute node carrying a few thousand datapath flows hit a soft lockup inside a single netlink flow dump and panicked. ovs_flow_cmd_dump() calls ovs_flow_stats_get() for every flow it emits, and that releases stats->lock with spin_unlock_bh() once per CPU that has touched the flow. Every release is a local_bh_enable(), and each one runs the pending softirq backlog in the dumping thread's own context. The skb bounds the flows one callback emits, but not the softirq work it absorbs. On a CPU that carries the box's packet load the backlog refills as fast as it drains, so the dumping thread becomes that CPU's softirq engine. It never sleeps and it has no reschedule point, so under voluntary preemption nothing can take the CPU away from it: neither the ksoftirqd the kernel woke to take the work over, nor the stopper thread the softlockup detector dispatches to refresh its timestamp. Hold BH off across the whole callback instead, the way ctnetlink_dump_table() does, so the nested spin_unlock_bh() stop draining softirqs. The loop already runs under rcu_read_lock() and cannot sleep. What it gives up is preemption under CONFIG_PREEMPT, since a BH-off region is not preemptible outside PREEMPT_RT. The region stays short: the skb caps the flows one callback emits, and empty buckets cost no skb space but are each visited once per dump, as the cursor only moves forward. The table grows on insert and shrinks only on flush, so the walk is bounded by the largest flow count the datapath has held. The softirq backlog the callback used to absorb has no bound at all.

Linux

In the Linux kernel, the following vulnerability has been resolved: drm/vmwgfx: validate pitch coming from userspace Validate the pitch, alongside the box dimensions before trying to copy data from the underlying surface. Fixes possible out of bounds reads with cursor snooping.

Linux

In the Linux kernel, the following vulnerability has been resolved: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch() __htab_map_lookup_and_delete_batch() has no rescheduling point. The batch count bounds how many entries are copied out, not how many buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the map end to end. The empty-bucket fast path is worse: it stays inside a single rcu_read_lock() / bpf_disable_instrumentation() section for any run of consecutive empty buckets. That holds up on small maps, but it falls apart at scale. On a 144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216 buckets held a CPU inside the batch op for 77+ seconds and triggered the soft lockup watchdog. Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this same problem in the generic batch ops, but not in this htab-native path, which every htab-based hash map variant uses for its lookup[_and_delete] batch ops. Complete that fix here. Leave the critical section after 64 consecutive empty buckets, call cond_resched_tasks_rcu_qs(), and resume at the saved bucket cursor. No locks are held at that point, and resuming from the cursor is already the function's behavior for non-empty buckets. Add the same call to the per-bucket loop after copy_to_user(), where every lock has been dropped. cond_resched_rcu() is not enough here: sleeping with bpf_prog_active elevated makes tracing programs on that CPU silently skip their invocations. Plain cond_resched() is not enough either. It is a no-op under PREEMPT and PREEMPT_LAZY, the only models arm64 and x86 have offered since commit 7dadeaa6e851 ("sched: Further restrict the preemption modes"). It is also never a Tasks RCU quiescent state, in any model: the reschedule counts as a preemption. The walking task stays a holdout and stalls every synchronize_rcu_tasks() caller, ftrace and BPF trampoline teardown included, until the syscall returns [1]. cond_resched_tasks_rcu_qs() is the usual tool for that [2]. It reports the quiescent state at each yield and still reschedules as cond_resched() does on PREEMPT_NONE and PREEMPT_VOLUNTARY kernels.

Linux

In the Linux kernel, the following vulnerability has been resolved: drm/nouveau/clk: fix list cursor use after loop in nvkm_clk_ustate_update If list_for_each_entry() exits without hitting a break then "pstate" is not a valid pstate pointer. Introduce a "found" variable instead. The check is reachable from userspace: nvkm_clk_ustate_update() takes the pstate id straight from the 'pstate' debugfs file, so requesting an id that is not in clk->states - or any id at all when the perf tables are broken and the list is empty - makes the pstate->pstate != req test dereference the list head cast to a struct nvkm_pstate, which is an out-of-bounds read. [Francesco: rebased on drm-misc-next, expanded the commit message]

Linux

In the Linux kernel, the following vulnerability has been resolved: net: usb: sr9700: include receive overhead in the length check The receive fixup subtracts the Ethernet CRC from the reported packet length, but compares that payload length against the whole remaining receive buffer. The following copy starts after the three-byte header, and the cursor advance consumes both that header and the four-byte CRC. Require the payload to fit after SR_RX_OVERHEAD before copying it or advancing to the next packet. The loop already ensures that the remaining buffer is larger than the overhead, so the subtraction is safe. The issue was found by our static-analysis tool.

Linux

In the Linux kernel, the following vulnerability has been resolved: nfc: st21nfca: validate received frame size st21nfca_hci_i2c_repack() trims a received frame at its EOF marker before removing byte stuffing. It then assumes the truncated frame contains the LLC header and two CRC bytes, and it unconditionally reads the byte after an escape marker. A malformed frame can place EOF immediately after the start marker or can end its data portion with an escape marker. The former leaves too few bytes for check_crc(), while the latter makes the unstuffing loop read past the current skb length. Require the minimum framing bytes both before and after unstuffing. Use separate input and output cursors while removing byte stuffing, and reject an escape marker without its encoded byte. This keeps malformed frames within the received frame boundary before CRC processing.

Linux

In the Linux kernel, the following vulnerability has been resolved: net: atl1c: fix soft lockup on out-of-range tpd_cons read The hardware can report an out-of-range tpd_cons (seen as 0xffff) while the PCIe link/MAC is resetting. An out-of-range value can never be reached and the loop below would spin forever. To avoid a soft lockup treat it as "nothing new to clean" instead. Reproduced on two machines, same NIC (Qualcomm Atheros AR8151 v2.0, 4-port), triggered by rebooting a Mikrotik CCR2004 PCIe card that the ports are directly linked to: - Ubuntu 26.04.1 LTS, kernel 7.0.0-31-generic. The link-flap precursor, before the lockup was captured with a full trace elsewhere: atl1c 0000:05:00.0 enp5s0f0: NETDEV WATCHDOG: CPU: 4: transmit queue 2 timed out 489984 ms atl1c 0000:05:00.0: MAC state machine can't be idle since disabled for 10ms second atl1c 0000:05:00.0: atl1c: enp5s0f0 NIC Link is Up<65535 Mbps Full Duplex> 65535 (0xffff) here is the same value tpd_cons reads back once the loop below gets stuck. - Proxmox VE, kernel 7.0.14-11-pve. Same NIC/trigger, this time caught by the soft lockup watchdog with a full stack trace: watchdog: BUG: soft lockup - CPU#12 stuck for 354s! [napi/eth%d-0:329] CPU: 12 UID: 0 PID: 329 Comm: napi/eth%d-0 Tainted: P O L 7.0.14-11-pve #1 PREEMPT(lazy) RIP: 0010:atl1c_clean_tx+0x142/0x2d0 [atl1c] Call Trace: <TASK> __napi_poll+0x32/0x1e0 napi_threaded_poll_loop+0x286/0x2e0 napi_threaded_poll+0xfd/0x140 kthread+0xf7/0x130 ret_from_fork+0x2da/0x3a0 ret_from_fork_asm+0x1a/0x30 </TASK>

Linux

In the Linux kernel, the following vulnerability has been resolved: net: bridge: mdb: restart port group walk after deletion br_mdb_flush_pgs() keeps a pointer-to-pointer cursor while walking mp->ports. br_multicast_del_pg() can re-enter the same MDB entry through br_multicast_sg_del_exclude_ports() and unlink other port groups. If the cursor points into one of those groups, the next iteration dereferences a stale cursor and can leave mp->ports pointing at freed memory. A following RTM_GETMDB exposes the dangling pointer: BUG: KASAN: slab-use-after-free in br_mdb_dump Read of size 8 br_mdb_dump rtnl_mdb_dump rtnl_dumpit netlink_dump Reset the cursor to mp->ports after every deletion. The deletion removes at least the selected group, so the restarted walk always makes progress.

Linux

In the Linux kernel, the following vulnerability has been resolved: xfs: fix cursor and pointer handling when recovering iunlink buckets LOLLM pointed out a bug in xlog_recover_iunlink_bucket: 1. We don't null out prev_ip after releasing it, which can lead to UAF problems if the inodegc flush call in the loop fails. at which point I noticed even more bugs: 2. If the inodegc flush inside the loop fails, we also leak @ip. 3. We set prev_agino to agino having already advanced agino, which results in inodes with i_prev_unlinked set to itself. 4. If we exit the bottom of the loop with prev_ip set, then prev_ip aliases ip and we also set its i_prev_unlinked to itself. Bugs 3 and 4 introduce loops into the unlinked list, though these loops don't surface because we immediately flush each unlinked inode after loading it. Fix all of these issues.