Veille CVE

Samedi 22 août 2026

2 CVE

Critique 0 Élevée 1 Moyenne 0 Faible 0 Non évaluée 1 Exploitées (KEV) Tri : plus récentes « ISC BIND 9 » ✕
  1. CVE-2026-74667 7.8 Élevée

    Linux

    In the Linux kernel, the following vulnerability has been resolved: net/packet: reset the MAC header on the packet-socket transmit path packet_parse_headers() resets the MAC header only for a SOCK_RAW frame whose socket did not bind a protocol. A protocol-bound SOCK_RAW socket, any SOCK_DGRAM frame, and the legacy SOCK_PACKET path therefore leave skb->mac_header unset here. For frames sent via __dev_queue_xmit() this is harmless: it resets the MAC header unconditionally. But the packet-socket PACKET_QDISC_BYPASS path uses dev_direct_xmit(), which does not, so the frame reaches ndo_start_xmit() with the MAC header unset. A driver that reads eth_hdr(skb) on transmit then dereferences skb->head + (u16)~0, an out-of-bounds access ~64 KiB past the head -- the same class fixed for one consumer in commit f5089008f90c ("macsec: do not read an unset MAC header in macsec_encrypt()"). packet_parse_headers() runs only on the transmit path, where skb->data points at the start of the L2 header for every packet-socket type regardless of its length: SOCK_RAW and SOCK_PACKET carry a user-supplied header and SOCK_DGRAM has one built by dev_hard_header(). Reset the MAC header unconditionally, mirroring __dev_queue_xmit(), so the frame is anchored on the bypass path too. Found by 0sec (https://0sec.ai) using automated source analysis; verified against source and matched to the macsec KASAN report in f5089008f90c. Compile-tested.

  2. CVE-2026-74639 – Non évaluée

    Linux

    In the Linux kernel, the following vulnerability has been resolved: ALSA: us144mkii: re-anchor capture URBs on resubmission capture_urb_complete() resubmits each capture URB without anchoring it: usb_get_urb(urb); ret = usb_submit_urb(urb, GFP_ATOMIC); Anchoring is a property of a submission, not of the URB. The giveback path calls usb_unanchor_urb() before urb->complete(), so an URB resubmitted from its own completion handler is off the anchor. The capture URBs are anchored once, at stream start, so from the first completion onward tascam->capture_anchor is empty. tascam_free_urbs(), tascam_disconnect(), tascam_suspend() and the stop-work path all call usb_kill_anchored_urbs(&tascam->capture_anchor) to reap the capture URBs before anything is freed. With the anchor empty those calls return immediately and the URBs stay queued on the host controller. tascam_free_urbs() then returns the capture transfer buffers with usb_free_coherent(), and snd_card_free() releases the snd_card allocation that embeds tascam (card->private_data). The controller completes the queued URBs afterwards, writing device-supplied data into the freed transfer buffer, and capture_urb_complete() dereferences the freed driver object. KASAN on 7.2.0-rc5 (arm64): BUG: KASAN: slab-use-after-free in dummy_timer Write of size 512 at addr ffff000015b62000 __asan_memcpy dummy_timer hrtimer_run_softirq Allocated by task 64: usb_alloc_coherent tascam_alloc_urbs tascam_probe Freed by task 170: usb_free_coherent tascam_free_urbs tascam_disconnect usb_unbind_interface BUG: KASAN: slab-use-after-free in capture_urb_complete Read of size 4 at addr ffff0000170ee878 Freed by task 170: release_card_device snd_card_free tascam_disconnect Restore the usb_anchor_urb() between the reference count bump and the resubmission. That also makes the handler's usb_unanchor_urb() failure arm meaningful again and restores usb_kill_anchored_urbs() as a barrier on the disconnect, suspend and stop-work paths. The anchoring was removed on the premise that the URB is already anchored from the initial submission, which does not hold once the first giveback has run. Discovered by XBOW, triaged by Baul Lee <baul.lee@xbow.com>