Vendredi 26 juin 2026

wolfSSL · Wolfssl wolfssl

The ML-KEM ARM64 NEON ciphertext comparison only compares half of the input, breaking the Fujisaki-Okamoto transform's implicit rejection and weakening IND-CCA2 security on that code path. The constant-time comparison effectively ignored part of the re-encrypted ciphertext, so a decapsulating party could fail to detect a manipulated ciphertext and proceed without the standard's required implicit rejection.

wolfSSL · Wolfssl wolfssl

PKCS#12 MAC verification uses an attacker-controlled comparison length, weakening the integrity check on the MAC and allowing a mismatched MAC to be accepted. The PKCS#12 verify path compared the locally computed HMAC against the MAC parsed from the PKCS#12 structure using a length taken directly from the attacker-supplied input, without first verifying that it equals the length of the digest actually produced by the configured algorithm. A truncated or zero-length stored MAC could therefore be accepted, defeating the integrity protection of the MAC.

wolfSSL · Wolfssl wolfssl

When HAVE_ENCRYPT_THEN_MAC is configured, the implementation could fall back to MAC-then-Encrypt rather than enforcing Encrypt-then-MAC.

wolfSSL · Wolfssl wolfssl

TLS 1.3 post-handshake authentication (PHA) issue where a server could accept a client's Finished message without the client having sent a Certificate and CertificateVerify. The post-handshake-auth exemption that allows an empty/absent peer certificate was only intended for the initial handshake, but it was also being applied while a post-handshake CertificateRequest was still outstanding. The check is now scoped to the initial handshake only: on the server, once a post-handshake CertificateRequest has been sent (certReqCtx is set), a peer certificate and a valid CertificateVerify are required again before the Finished is accepted, with empty-certificate handling following the configured verify mode (FAIL_IF_NO_PEER_CERT) just as during first-handshake client authentication. Only affects TLS 1.3 servers built with post-handshake authentication support (WOLFSSL_POST_HANDSHAKE_AUTH / --enable-postauth, included in --enable-all) that enable WOLFSSL_VERIFY_POST_HANDSHAKE and request a client certificate after the handshake via wolfSSL_request_certificate(). Clients, and servers that do not use post-handshake authentication, are unaffected.

wolfSSL · Wolfssl wolfssl

OCSP CertID serial-number length-confusion in wolfSSL_OCSP_resp_find_status allows a same-issuer SingleResponse whose serial is a prefix of the target serial to be reported as the revocation status of a different certificate. The lookup compared serial-number bytes without first requiring the two serial numbers to be of equal length, so a SingleResponse for one certificate (same issuer) whose serial is a prefix of the target's serial would match, returning the wrong certificate's status. The fix requires the serial lengths to be equal before comparing the serial bytes.