Veille CVE

Lundi 27 avril 2026

7 CVE

Critique 0 Élevée 3 Moyenne 4 Faible 0 Non évaluée 0 Exploitées (KEV) Tri : plus récentes « kernel » ✕
  1. CVE-2026-31691 5.5 Moyenne

    Linux · Linux linux kernel

    In the Linux kernel, the following vulnerability has been resolved: igb: remove napi_synchronize() in igb_down() When an AF_XDP zero-copy application terminates abruptly (e.g., kill -9), the XSK buffer pool is destroyed but NAPI polling continues. igb_clean_rx_irq_zc() repeatedly returns the full budget, preventing napi_complete_done() from clearing NAPI_STATE_SCHED. igb_down() calls napi_synchronize() before napi_disable() for each queue vector. napi_synchronize() spins waiting for NAPI_STATE_SCHED to clear, which never happens. igb_down() blocks indefinitely, the TX watchdog fires, and the TX queue remains permanently stalled. napi_disable() already handles this correctly: it sets NAPI_STATE_DISABLE. After a full-budget poll, __napi_poll() checks napi_disable_pending(). If set, it forces completion and clears NAPI_STATE_SCHED, breaking the loop that napi_synchronize() cannot. napi_synchronize() was added in commit 41f149a285da ("igb: Fix possible panic caused by Rx traffic arrival while interface is down"). napi_disable() provides stronger guarantees: it prevents further scheduling and waits for any active poll to exit. Other Intel drivers (ixgbe, ice, i40e) use napi_disable() without a preceding napi_synchronize() in their down paths. Remove redundant napi_synchronize() call and reorder napi_disable() before igb_set_queue_napi() so the queue-to-NAPI mapping is only cleared after polling has fully stopped.

  2. CVE-2026-31690 7.8 Élevée

    Linux · Linux linux kernel

    In the Linux kernel, the following vulnerability has been resolved: firmware: thead: Fix buffer overflow and use standard endian macros Addresses two issues in the TH1520 AON firmware protocol driver: 1. Fix a potential buffer overflow where the code used unsafe pointer arithmetic to access the 'mode' field through the 'resource' pointer with an offset. This was flagged by Smatch static checker as: "buffer overflow 'data' 2 <= 3" 2. Replace custom RPC_SET_BE* and RPC_GET_BE* macros with standard kernel endianness conversion macros (cpu_to_be16, etc.) for better portability and maintainability. The functionality was re-tested with the GPU power-up sequence, confirming the GPU powers up correctly and the driver probes successfully. [ 12.702370] powervr ffef400000.gpu: [drm] loaded firmware powervr/rogue_36.52.104.182_v1.fw [ 12.711043] powervr ffef400000.gpu: [drm] FW version v1.0 (build 6645434 OS) [ 12.719787] [drm] Initialized powervr 1.0.0 for ffef400000.gpu on minor 0

  3. CVE-2026-31689 5.5 Moyenne

    Linux · Linux linux kernel

    In the Linux kernel, the following vulnerability has been resolved: EDAC/mc: Fix error path ordering in edac_mc_alloc() When the mci->pvt_info allocation in edac_mc_alloc() fails, the error path will call put_device() which will end up calling the device's release function. However, the init ordering is wrong such that device_initialize() happens *after* the failed allocation and thus the device itself and the release function pointer are not initialized yet when they're called: MCE: In-kernel MCE decoding enabled. ------------[ cut here ]------------ kobject: '(null)': is not initialized, yet kobject_put() is being called. WARNING: lib/kobject.c:734 at kobject_put, CPU#22: systemd-udevd CPU: 22 UID: 0 PID: 538 Comm: systemd-udevd Not tainted 7.0.0-rc1+ #2 PREEMPT(full) RIP: 0010:kobject_put Call Trace: <TASK> edac_mc_alloc+0xbe/0xe0 [edac_core] amd64_edac_init+0x7a4/0xff0 [amd64_edac] ? __pfx_amd64_edac_init+0x10/0x10 [amd64_edac] do_one_initcall ... Reorder the calling sequence so that the device is initialized and thus the release function pointer is properly set before it can be used. This was found by Claude while reviewing another EDAC patch.

  4. CVE-2026-31687 5.5 Moyenne

    Linux · Linux linux kernel

    In the Linux kernel, the following vulnerability has been resolved: gpio: omap: do not register driver in probe() Commit 11a78b794496 ("ARM: OMAP: MPUIO wake updates") registers the omap_mpuio_driver from omap_mpuio_init(), which is called from omap_gpio_probe(). However, it neither makes sense to register drivers from probe() callbacks of other drivers, nor does the driver core allow registering drivers with a device lock already being held. The latter was revealed by commit dc23806a7c47 ("driver core: enforce device_lock for driver_match_device()") leading to a potential deadlock condition described in [1]. Additionally, the omap_mpuio_driver is never unregistered from the driver core, even if the module is unloaded. Hence, register the omap_mpuio_driver from the module initcall and unregister it in module_exit().

  5. CVE-2026-31686 7.8 Élevée

    Linux · Linux linux kernel

    In the Linux kernel, the following vulnerability has been resolved: mm/kasan: fix double free for kasan pXds kasan_free_pxd() assumes the page table is always struct page aligned. But that's not always the case for all architectures. E.g. In case of powerpc with 64K pagesize, PUD table (of size 4096) comes from slab cache named pgtable-2^9. Hence instead of page_to_virt(pxd_page()) let's just directly pass the start of the pxd table which is passed as the 1st argument. This fixes the below double free kasan issue seen with PMEM: radix-mmu: Mapped 0x0000047d10000000-0x0000047f90000000 with 2.00 MiB pages ================================================================== BUG: KASAN: double-free in kasan_remove_zero_shadow+0x9c4/0xa20 Free of addr c0000003c38e0000 by task ndctl/2164 CPU: 34 UID: 0 PID: 2164 Comm: ndctl Not tainted 6.19.0-rc1-00048-gea1013c15392 #157 VOLUNTARY Hardware name: IBM,9080-HEX POWER10 (architected) 0x800200 0xf000006 of:IBM,FW1060.00 (NH1060_012) hv:phyp pSeries Call Trace: dump_stack_lvl+0x88/0xc4 (unreliable) print_report+0x214/0x63c kasan_report_invalid_free+0xe4/0x110 check_slab_allocation+0x100/0x150 kmem_cache_free+0x128/0x6e0 kasan_remove_zero_shadow+0x9c4/0xa20 memunmap_pages+0x2b8/0x5c0 devm_action_release+0x54/0x70 release_nodes+0xc8/0x1a0 devres_release_all+0xe0/0x140 device_unbind_cleanup+0x30/0x120 device_release_driver_internal+0x3e4/0x450 unbind_store+0xfc/0x110 drv_attr_store+0x78/0xb0 sysfs_kf_write+0x114/0x140 kernfs_fop_write_iter+0x264/0x3f0 vfs_write+0x3bc/0x7d0 ksys_write+0xa4/0x190 system_call_exception+0x190/0x480 system_call_vectored_common+0x15c/0x2ec ---- interrupt: 3000 at 0x7fff93b3d3f4 NIP: 00007fff93b3d3f4 LR: 00007fff93b3d3f4 CTR: 0000000000000000 REGS: c0000003f1b07e80 TRAP: 3000 Not tainted (6.19.0-rc1-00048-gea1013c15392) MSR: 800000000280f033 <SF,VEC,VSX,EE,PR,FP,ME,IR,DR,RI,LE> CR: 48888208 XER: 00000000 <...> NIP [00007fff93b3d3f4] 0x7fff93b3d3f4 LR [00007fff93b3d3f4] 0x7fff93b3d3f4 ---- interrupt: 3000 The buggy address belongs to the object at c0000003c38e0000 which belongs to the cache pgtable-2^9 of size 4096 The buggy address is located 0 bytes inside of 4096-byte region [c0000003c38e0000, c0000003c38e1000) The buggy address belongs to the physical page: page: refcount:0 mapcount:0 mapping:0000000000000000 index:0x0 pfn:0x3c38c head: order:2 mapcount:0 entire_mapcount:0 nr_pages_mapped:0 pincount:0 memcg:c0000003bfd63e01 flags: 0x63ffff800000040(head|node=6|zone=0|lastcpupid=0x7ffff) page_type: f5(slab) raw: 063ffff800000040 c000000140058980 5deadbeef0000122 0000000000000000 raw: 0000000000000000 0000000080200020 00000000f5000000 c0000003bfd63e01 head: 063ffff800000040 c000000140058980 5deadbeef0000122 0000000000000000 head: 0000000000000000 0000000080200020 00000000f5000000 c0000003bfd63e01 head: 063ffff800000002 c00c000000f0e301 00000000ffffffff 00000000ffffffff head: ffffffffffffffff 0000000000000000 00000000ffffffff 0000000000000004 page dumped because: kasan: bad access detected [ 138.953636] [ T2164] Memory state around the buggy address: [ 138.953643] [ T2164] c0000003c38dff00: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc [ 138.953652] [ T2164] c0000003c38dff80: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc [ 138.953661] [ T2164] >c0000003c38e0000: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc [ 138.953669] [ T2164] ^ [ 138.953675] [ T2164] c0000003c38e0080: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc [ 138.953684] [ T2164] c0000003c38e0100: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc [ 138.953692] [ T2164] ================================================================== [ 138.953701] [ T2164] Disabling lock debugging due to kernel taint

  6. CVE-2026-7141 5.6 Moyenne

    vLLM · Vllm vllm

    A vulnerability was found in vLLM up to 0.19.0. The affected element is the function has_mamba_layers of the file vllm/v1/kv_cache_interface.py of the component KV Block Handler. Performing a manipulation results in uninitialized resource. It is possible to initiate the attack remotely. The attack is considered to have high complexity. The exploitability is described as difficult. The exploit has been made public and could be used. The existence of this vulnerability is still disputed at present. The proposed patch did not fix the issue. A 3rd party explains: "The divergence could be explained by a benign and expected vLLM behavior where vLLM server could group concurrent requests together resulting in different input shapes based on varying request arrival time. The differences in grouped input shapes could call different kernels with could produce difference results due to rounding and differences in order of operations. There is an environment variable VLLM_BATCH_INVARIANT=1 for users that desire to have deterministic output with temperature 0.0."

  7. CVE-2026-3006 7.0 Élevée

    WinFSP · Red Hat Advanced Cluster Management for Kubernetes 2

    Successful exploitation of the race condition vulnerability could allow an attacker to trigger a kernel heap overflow, potentially leading to local privilege escalation and granting system-level access to the affected software.