Lundi 19 octobre 2026

mcollina msgpack5

msgpack5 is a msgpack v5 implementation for node.js and the browser. Prior to 6.1.0, the decoder reads the four-byte length of a map32 value before validating that the complete five-byte header is available. A truncated map32 header therefore causes a checked out-of-bounds buffer read and throws RangeError instead of IncompleteBufferError, which can unexpectedly terminate a request, stream, or worker in applications that wait for additional bytes after IncompleteBufferError. There is no adjacent-memory disclosure because the buffer implementation checks bounds. This issue is fixed in version 6.1.0.

mz-automation libiec61850

libIEC61850 is an open-source implementation of IEC 61850 client and server protocols including MMS, GOOSE, Sampled Values, and R-Session. Prior to 1.6.2, parseUserInformation in src/mms/iso_acse/acse.c checks len for zero before validating the negative bufPos returned by BerDecoder_decodeLength for a truncated long-form length. The continue path therefore swallows the error, reads buffer[-1], resets parsing to the beginning, and repeats the same malformed state. An unauthenticated remote peer can send a malformed AARE PDU during association to cause an infinite CPU loop under a normal allocator or a one-byte out-of-bounds read and process abort when the preceding byte is inaccessible. This issue is fixed in version 1.6.2.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: verisilicon: rockchip: reject AV1 frames exceeding the tile capacity rockchip_vpu981_av1_dec_set_tile_info() indexes the tile group entry array by tile1 * tile_cols + tile0, reading up to tile_cols * tile_rows entries, lays out one descriptor per tile in the AV1_MAX_TILES tile_info buffer, and programs the real tile_cols / tile_rows into the hardware. The tile group entry control is a dynamic array sized to the number of entries userspace submitted, independent of tile_cols / tile_rows, so a frame that claims more tiles than entries reads past the array. A frame that claims more than AV1_MAX_TILES tiles also leaves the hardware programmed for more tiles than the descriptor buffer holds. Reject both in prepare_run(): tile_cols * tile_rows must not exceed the submitted entry count or AV1_MAX_TILES. The entry count is read via v4l2_ctrl_find() (ctrl->elems). This mirrors the bound the mediatek AV1 decoder already enforces.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: v4l2-ctrls: validate HEVC tile counts The stateless HEVC decoders read num_tile_columns_minus1 + 1 entries from column_width_minus1[] and num_tile_rows_minus1 + 1 from row_height_minus1[] and use them as tile-loop bounds, but std_validate_compound() does not bound these u8 counts. Reject a V4L2_CTRL_TYPE_HEVC_PPS with tiling enabled whose tile counts exceed the uAPI array capacity, mirroring the existing compound-control range checks.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: v4l2-ctrls: validate AV1 tile counts The stateless AV1 decoders use tile_info.tile_cols and tile_rows as loop bounds and as indices into the mi_*_starts[] and *_in_sbs_minus_1[] arrays, as the divisor for context_update_tile_id, and their product bounds the per-tile descriptor buffers, but std_validate_compound() does not bound these u8 fields. Reject a V4L2_CTRL_TYPE_AV1_FRAME whose tile_cols or tile_rows exceeds V4L2_AV1_MAX_TILE_COLS / _ROWS, or whose product exceeds V4L2_AV1_MAX_TILE_COUNT. A zero tile count is left to the consuming driver so the zero-initialised control that existing userspace submits is still accepted.

Linux

In the Linux kernel, the following vulnerability has been resolved: NFSv4.2: fix LAYOUTSTATS send buffer exhaustion encode_layoutstats_maxsz budgets XDR_QUADLEN(PNFS_LAYOUTSTATS_MAXSIZE), i.e. 256 bytes, for the layoutupdate4 body written by the layout driver. The flexfiles record can exceed that. ff_layout_encode_ff_layoutupdate() emits, per data server, a netaddr4, an nfs_fh4, two ff_io_latency4, an nfstime4 and a bool. A data server whose filehandle is NFS_MAXFHSIZE bytes long already accounts for 132 of those bytes, and the two ff_io_latency4 at 64 bytes each, the nfstime4 and the bool add a further 144, so the body passes 256 bytes before the netaddr4 is encoded at all. encode_layoutstats() additionally writes the deviceid4 and the layoutupdate4 lou_type word, neither of which the macro accounts for. The filehandle and the address are both chosen by the server, through LAYOUTGET and GETDEVICEINFO, so it can drive the encoder past the end of the send buffer. xdr_reserve_space() returns NULL once that happens, and the two ff_layout_encode_io_latency() calls run with dss_info->mirror->lock held, so a NULL return there leaves the lock permanently held. Raise PNFS_LAYOUTSTATS_MAXSIZE to 384 so that the record fits inside the reservation.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: rkvdec: hevc: guard INTER_REF_PIC_SET_PRED index underflow st_ref_pic_set_prediction() computes the reference RPS index as st_rps_idx - (delta_idx_minus1 + 1) per HEVC spec equation 7-59. Both operands are u8, so when delta_idx_minus1 + 1 exceeds the current index the subtraction wraps and the subsequent array access at calculated_rps_st_sets[ref_rps_idx] reads far out of bounds. A userspace V4L2 client that can open the RKVDEC m2m decoder can submit an EXT_SPS_ST_RPS control with INTER_REF_PIC_SET_PRED set and delta_idx_minus1 crafted to trigger the underflow. Reject the entry early when the reference index would underflow.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: v4l2-ctrls: validate HEVC EXT SPS RPS counts The HEVC SPS control carries the short-term and long-term RPS counts that decoder drivers use to walk the matching EXT SPS dynamic arrays. Reject SPS values that exceed the HEVC limits of 64 short-term sets and 32 long-term references so drivers cannot later index beyond those controls. Also reject EXT SPS ST RPS entries whose negative or positive picture counts exceed the 16-entry arrays, or whose combined delta-POC count exceeds the HEVC DPB maximum.

Linux

In the Linux kernel, the following vulnerability has been resolved: media: vicodec: fix out-of-bounds write in FWHT encoder vidioc_s_fmt_vid_out() sizes the encoder CAPTURE buffer from the compressed descriptor pixfmt_fwht, whose sizeimage_mult is 3: coded_w * coded_h * 3 + sizeof(struct fwht_cframe_hdr). fwht_encode_frame() encodes one plane per component, and an incompressible plane takes the FWHT_FRAME_UNENCODED path in encode_plane(), copying the plane verbatim. For a 4-component pixel format all four planes are full resolution (width_div == height_div == 1), so a frame that forces every plane through the unencoded fallback writes sizeof(struct fwht_cframe_hdr) + 4 * coded_w * coded_h bytes, overrunning the plane by coded_w * coded_h, which can result in corruption of adjacent kernel heap memory. Bump pixfmt_fwht.sizeimage_mult from 3 to 4, matching the largest components_num among the supported raw formats, so the capture buffer is always large enough for the unencoded fallback.

Linux

In the Linux kernel, the following vulnerability has been resolved: ubifs: fix out-of-bounds read in signature length check ubifs_sb_verify_signature() bounds the on-disk ubifs_sig_node->len field before handing the signature payload to verify_pkcs7_signature(), but the check has the wrong sign: if (le32_to_cpu(signode->len) > snod->len + sizeof(struct ubifs_sig_node)) The signature bytes start sizeof(struct ubifs_sig_node) (UBIFS_SIG_NODE_SZ, 64 bytes) into the node, so the payload is at most snod->len - sizeof(struct ubifs_sig_node) bytes long. Adding the header size instead of subtracting it accepts a declared length up to 2 * UBIFS_SIG_NODE_SZ larger than the node actually holds -- past the end of c->sbuf, which is vmalloc(c->leb_size). verify_pkcs7_signature() -> pkcs7_parse_message() -> asn1_ber_decoder() is then handed that inflated length and reads beyond the allocation while walking the DER headers. The node length comes straight from the mounted image, so a crafted signed UBIFS image reaches this via ubifs_read_superblock() before the signature is cryptographically checked. snod->len is guaranteed to be >= UBIFS_SIG_NODE_SZ by the node scanner (c->ranges[UBIFS_SIG_NODE].min_len == UBIFS_SIG_NODE_SZ), so the corrected subtraction cannot underflow. Legitimately signed images are unaffected: a correct superblock never declares a signature longer than the node it is embedded in.

Linux

In the Linux kernel, the following vulnerability has been resolved: nfsd: cap decoded POSIX ACL count to bound sort cost nfsd4_decode_posixacl() reads a u32 entry count off the wire and passes it straight to posix_acl_alloc() and sort_pacl_range(). The latter is an O(n^2) bubble sort, so a client-chosen count drives unbounded CPU in the server's compound processing path. nfsd4_decode_posixacl() xdr_stream_decode_u32(&count) /* uncapped u32 */ posix_acl_alloc(count, GFP_KERNEL) sort_pacl_range(*acl, 0, count - 1) /* O(n^2) bubble sort */ The encoder side in the same file already rejects ACLs whose a_count exceeds NFS_ACL_MAX_ENTRIES, but the decoder introduced in commit 5fc51dfc2eb1 ("NFSD: Add support for XDR decoding POSIX draft ACLs") omitted the symmetric check. Fix by rejecting a wire count greater than NFS_ACL_MAX_ENTRIES with nfserr_inval, before any allocation, so the sort is bounded by NFS_ACL_MAX_ENTRIES^2 comparisons. While we're in here, also fix the nfserr_resource return if posix_acl_alloc() fails. That's not a legal error code for v4.1+. Change it to return nfserr_jukebox as that's more appropriate for memory allocation failures.

Linux

In the Linux kernel, the following vulnerability has been resolved: nfsd: reject out-of-range useconds in NFSv2 SETATTR/CREATE The NFSv2 sattr decoder converts the wire useconds to nanoseconds in svcxdr_decode_sattr(): iap->ia_atime.tv_nsec = tmp2 * NSEC_PER_USEC; tmp2 is a u32 and NSEC_PER_USEC is 1000, so the product is computed in unsigned long. On ILP32 that is 32 bits, and an out-of-range useconds value such as 4294968 wraps to tv_nsec == 704. The corruption therefore happens during decode, before any proc function can inspect the value, and a later range check on tv_nsec would see an in-range result and accept it. Rejecting in the decoder yields an RPC GARBAGE_ARGS reply. NFSv2 defines no NFSERR_INVAL, so there is no NFS-level status to return for a malformed time argument, and the check cannot move to the proc function the way the v3/v4 nsec range checks do. Guard the raw useconds before the multiplication and reject values greater than 1000000. useconds == 1000000 is kept: it is the Sun convention for "set to the current server time", and the in-tree Linux NFSv2 client emits it in both the atime and the mtime field for a plain touch / utimes(file, NULL) (see encode_sattr() and xdr_encode_current_server_time() in fs/nfs/nfs2xdr.c). Rejecting 1000000 would turn that common operation into a hard decode failure for both SETATTR and CREATE. 1000000 * NSEC_PER_USEC is 10^9, which does not wrap on ILP32, so the Sun convention value passes through safely. Only genuinely out-of-range values (> 1000000) are rejected. The atime and mtime guards are therefore symmetric. The decoder only applied the Sun convention in the mtime block, which clears ATTR_ATIME_SET|ATTR_MTIME_SET when mtime useconds == 1000000. If a client puts 1000000 in the atime field but not in the mtime field, the atime block stored an out-of-range tv_nsec (10^9) and left ATTR_ATIME_SET set, so the bogus value reached the filesystem. Apply the convention in the atime block as well, clearing ATTR_ATIME_SET so the server uses its current time and ignores the value. Only ATTR_ATIME_SET is cleared there. The mtime block keeps its existing behavior, where 1000000 means "set both atime and mtime to now". [ cel: various tweaks, addenda, and clean-ups ]