Veille CVE

Lundi 17 août 2026

2 CVE

Critique 0 Élevée 1 Moyenne 0 Faible 0 Non évaluée 1 Exploitées (KEV) Tri : plus récentes « Ubuntu linux kernel » ✕
  1. CVE-2026-64455 – Non évaluée

    Linux

    In the Linux kernel, the following vulnerability has been resolved: USB: chaoskey: Fix slab-use-after-free in chaoskey_release() The chaoskey driver has a use-after-free bug in its release routine. If the user closes the device file after the USB device has been unplugged, a debugging log statement will try to access the usb_interface structure after it has been deallocated: BUG: KASAN: slab-use-after-free in dev_driver_string (drivers/base/core.c:2406) Read of size 8 at addr ffff888168e8a0b8 by task chaoskey_raw_re/10106 Hardware name: QEMU Ubuntu 24.04 PC v2 (i440FX + PIIX, arch_caps fix, 1996), BIOS 1.16.3-debian-1.16.3-2 04/01/2014 Call Trace: <TASK> dump_stack_lvl (lib/dump_stack.c:94 lib/dump_stack.c:120) print_report (mm/kasan/report.c:378 mm/kasan/report.c:482) kasan_report (mm/kasan/report.c:595) dev_driver_string (drivers/base/core.c:2406) __dynamic_dev_dbg (lib/dynamic_debug.c:906) chaoskey_release (drivers/usb/misc/chaoskey.c:323) __fput (fs/file_table.c:510) fput_close_sync (fs/file_table.c:615) __x64_sys_close (fs/open.c:1507 fs/open.c:1492 fs/open.c:1492) do_syscall_64 (arch/x86/entry/syscall_64.c:63 arch/x86/entry/syscall_64.c:94) entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121) The driver's last reference to the interface structure is dropped in the chaoskey_free() routine, so the code must not use the interface -- even in a debugging statement -- after that routine returns. (Exception: If we know that another reference is held by someone else, such as the device core while the disconnect routine runs, there's no problem. Thanks to Johan Hovold for pointing this out.) Since the bad access is part of an unimportant debugging statement, we can fix the problem simply by removing the whole statement.

  2. CVE-2026-63827 7.8 Élevée

    Linux

    In the Linux kernel, the following vulnerability has been resolved: apparmor: fix use-after-free in rawdata dedup loop aa_replace_profiles() walks ns->rawdata_list to dedup the incoming policy blob against entries already attached to existing profiles. Per the kernel-doc on struct aa_loaddata, list membership does not hold a reference: profiles hold pcount, and when the last pcount drops, do_ploaddata_rmfs() is queued on a workqueue that takes ns->lock and removes the entry. Between dropping the last pcount and the workqueue running, an entry remains on the list with pcount == 0. aa_get_profile_loaddata() is an unconditional kref_get() on pcount, so when the dedup loop hits such an entry, refcount hardening reports refcount_t: addition on 0; use-after-free. inside aa_replace_profiles(), and the poisoned counter then trips "saturated" and "underflow" warnings on the subsequent uses of the same loaddata. Before commit a0b7091c4de4 ("apparmor: fix race on rawdata dereference") the dedup path used a get_unless_zero-style helper on a single counter, so the existing "if (tmp)" guard was meaningful. The split-refcount refactor introduced aa_get_profile_loaddata(), which has plain kref_get() semantics, and the guard quietly became a no-op. Introduce aa_get_profile_loaddata_not0(), matching the existing _not0 convention used by aa_get_profile_not0(), and use it for the rawdata_list dedup lookup so dying entries are skipped. Reproduced on x86_64 with v7.1-rc5 in QEMU+KVM running Ubuntu 24.04 + stress-ng 0.17.06: stress-ng --apparmor 1 --klog-check --timeout 60s Without this patch the three refcount_t warnings fire within a few seconds. With it the same 60 s run is clean. Coverage is a smoke-test only; a longer soak with CONFIG_KASAN, CONFIG_KCSAN and CONFIG_PROVE_LOCKING would be welcome from anyone with the cycles.