Samedi 25 juillet 2026

Linux

In the Linux kernel, the following vulnerability has been resolved: tty: serial: samsung: Remove redundant port lock acquisition in rx helpers Sashiko identified a deadlock when the console flow is engaged [1]. When console flow control is enabled (UPF_CONS_FLOW), s3c24xx_serial_stop_tx() calls s3c24xx_serial_rx_enable() and s3c24xx_serial_start_tx() calls s3c24xx_serial_rx_disable(). The serial core framework invokes the .stop_tx() and .start_tx() callbacks with the port->lock spinlock already held. Furthermore, all internal driver paths that invoke stop_tx (such as the DMA TX completion handler s3c24xx_serial_tx_dma_complete() or the PIO TX IRQ handler s3c24xx_serial_tx_irq()) also acquire port->lock prior to calling it. (Note that s3c24xx_serial_start_tx() is only invoked by the serial core). However, s3c24xx_serial_rx_enable() and s3c24xx_serial_rx_disable() unconditionally attempt to acquire port->lock again using uart_port_lock_irqsave(). Since spinlocks are not recursive, this causes a deadlock on the same CPU when console flow control is engaged. Remove the redundant lock acquisition from both rx helper functions.

Linux

In the Linux kernel, the following vulnerability has been resolved: drm/hyperv: validate VMBus packet size in receive callback hyperv_receive_sub() reads msg->vid_hdr.type and dispatches into one of four message-type branches without knowing how many bytes the host wrote into hv->recv_buf. The completion path then runs memcpy(hv->init_buf, msg, VMBUS_MAX_PACKET_SIZE), so the consumer that wakes on wait_for_completion_timeout() can read up to 16 KiB of residue from a prior message as if it were the response payload. Pass bytes_recvd into hyperv_receive_sub() and reject any packet that does not cover the pipe + synthvid header. A single switch on msg->vid_hdr.type then computes the type-specific payload size: the three completion-driving types (SYNTHVID_VERSION_RESPONSE, SYNTHVID_RESOLUTION_RESPONSE, SYNTHVID_VRAM_LOCATION_ACK) fall through to a shared exit that requires that size before memcpy/complete, while SYNTHVID_FEATURE_CHANGE validates its own payload and returns before reading is_dirt_needed. Unknown types are dropped. SYNTHVID_RESOLUTION_RESPONSE is variable length: the host fills resolution_count entries, not the full SYNTHVID_MAX_RESOLUTION_COUNT array. Validate the fixed prefix first so resolution_count can be read, bound it against the array, then require only the count-sized array, so the shorter responses the host actually sends are accepted. Only run the sub-handler when vmbus_recvpacket() returned success. The memcpy length is bytes_recvd, which is bounded by VMBUS_MAX_PACKET_SIZE only on a successful receive; on -ENOBUFS vmbus_recvpacket() instead reports the required length, which can exceed hv->recv_buf, so copying bytes_recvd would read and write past the 16 KiB buffers. Gating on the success return keeps the copy bounded. The nonzero-return path is itself a malformed-message case and is now logged rather than silently skipped; channel recovery is not attempted. Rejected packets are reported via drm_err_ratelimited() rather than silently dropped, matching the CoCo-hardened pattern in hv_kvp_onchannelcallback().

Linux

In the Linux kernel, the following vulnerability has been resolved: ethtool: tsconfig: fix missing ethnl_ops_complete() tsconfig_prepare_data() calls ethnl_ops_begin(), we need to call ethnl_ops_complete() before returning the error.

Linux

In the Linux kernel, the following vulnerability has been resolved: xfrm: move policy_bydst RCU sync from per-netns .exit to .pre_exit The struct pernet_operations docstring in include/net/net_namespace.h explicitly warns against blocking RCU primitives in .exit handlers: Exit methods using blocking RCU primitives, such as synchronize_rcu(), should be implemented via exit_batch. [...] Please, avoid synchronize_rcu() at all, where it's possible. Note that a combination of pre_exit() and exit() can be used, since a synchronize_rcu() is guaranteed between the calls. xfrm_policy_fini() violates this: it calls synchronize_rcu() before freeing the policy_bydst hash tables (so no RCU reader is mid- traversal at free time), but runs from xfrm_net_ops.exit -- once per namespace -- so a cleanup_net() of N namespaces pays N full RCU grace periods serially. Use the documented pre_exit/exit split. Move the policy flush (and the workqueue drains it depends on) into a new .pre_exit handler; xfrm_policy_fini() then runs in .exit and frees the hash tables after the synchronize_rcu_expedited() that cleanup_net() guarantees between the two phases. Providing O(1) RCU grace periods per batch instead of O(N). Observed on Linux 6.18 with a workload doing unshare(CLONE_NEWNET) at ~13/sec sustained: cleanup_net() and the netns_wq rescuer kthread both stuck in xfrm_policy_fini()'s synchronize_rcu(), >300k struct net accumulated in the cleanup queue, Percpu in /proc/meminfo climbed to 130+ GB on 256-CPU hosts, and memcg OOMs followed. setup_net and __put_net counts were balanced, ruling out a refcount leak.

Linux

In the Linux kernel, the following vulnerability has been resolved: pinctrl: meson: amlogic-a4: fix deadlock issue Accessing the pinconf-pins sysfs node may deadlock. pinconf_pins_show() holds pctldev->mutex, and the platform driver calls pinctrl_find_gpio_range_from_pin(), which tries to acquire the same mutex again, leading to a deadlock. Use pinctrl_find_gpio_range_from_pin_nolock() to fix this issue.

Linux

In the Linux kernel, the following vulnerability has been resolved: NFSD: Fix infinite loop in layout state revocation find_one_sb_stid() skips stids whose sc_status is non-zero, but the SC_TYPE_LAYOUT case in nfsd4_revoke_states() never sets sc_status before calling nfsd4_close_layout(). The retry loop therefore finds the same layout stid on every iteration, hanging the revoker indefinitely.

Linux

In the Linux kernel, the following vulnerability has been resolved: tcp: Fix out-of-bounds access for twsk in tcp_ao_established_key(). lockdep_sock_is_held() was added in tcp_ao_established_key() by the cited commit. It can be called from tcp_v[46]_timewait_ack() with twsk. Since it does not have sk->sk_lock, the lockdep annotation results in out-of-bound access. $ pahole -C tcp_timewait_sock vmlinux | grep size /* size: 288, cachelines: 5, members: 8 */ $ pahole -C sock vmlinux | grep sk_lock socket_lock_t sk_lock; /* 440 192 */ Let's not use lockdep_sock_is_held() for TCP_TIME_WAIT.

Linux

In the Linux kernel, the following vulnerability has been resolved: drm/xe/gsc: Fix double-free of managed BO in error path The error path in xe_gsc_init_post_hwconfig() explicitly frees a BO allocated with xe_managed_bo_create_pin_map() via xe_bo_unpin_map_no_vm(). Since the managed BO already has a devm cleanup action registered, this causes a double-free when devm unwinds during probe failure. Remove the explicit free and let devm handle it, consistent with all other xe_managed_bo_create_pin_map() callers. (cherry picked from commit 71d61e3e299a17139e47f980a4d6f425b2c59bf7)